Interceptor Starfighter ready to defend interstellar space from the forces of tyranny

Yellow - Taiidan
print at 8 x 8 inch

Gray - Rebel
print at 8 x 8 inch

Blue - Covenant
print at 8 x 8 inch

Tools:
- liquid craft glue
- small paint brush
- xacto blade
- straight edge
- pointy object to score the fold lines, a drafting pencil works well.

Carefully cut out each piece with the blade or scissors.

Score each dotted fold line using the straight edge and a pointed scoring tool ( or metal tipped drafting pencil works well )

Fold each piece along the scored edge lines. Fold dashed lines away from you and the dotted-dashed lines towards you.

Starting with the rear of the top-wings piece, apply glue to the underside using a small brush.

Attach the top flaps of the rear engine piece to the fresh glue starting with the center. Hold in place until the glue sets and the pieces become attached. Some experimentation may be required.

Finish attaching the top of the rear engine piece to the rear of the top wings piece.

Attached rear engine piece viewed from below.

Next, glue the left wing interior to the underside of the wings top piece.

Left wing interior from the top.

Glue the right wing interior to the underside of the wings top piece.

Wing interiors from the top.

Glue the cockpit into the nose from the underside.

Cockpit and nose from the top.

Glue the combined nose and cockpit to the wings. It might be helpful to press and hold the interior flaps in place with the back of the brush while the glue sets.

Attached nose from the top.

Attached nose from the bottom.

Next, glue the right wing’s bottom piece into place.

Glue the other wing’s bottom piece into place.

Next, glue the final bottom piece into place. It might be easier to start with one side and then after it’s set do the other final side.

Final bottom piece in place.

Final bottom piece in place viewed from the bottom-front.

Complete Interceptor Starfighter ready to enjoy.